Blower Motor Linear Controller

BLOWER MOTOR LINEAR CONTROLLER (Auto A/C)

INSPECTION

1. REMOVE GLOVE COMPARTMENT PARTS




2. REMOVE BLOWER MOTOR LINEAR CONTROLLER
a. Disconnect the connector.
b. Remove the 2 screws and controller.




3. INSPECT BLOWER MOTOR LINEAR CONTROLLER CIRCUIT
Connect the connector to the controller and inspect the wire harness side connector from the back side, as shown in the chart.




Test conditions:
- Turn ignition switch to ON
- Operate blower motor

It the circuit is as specified, try to replace the controller with a new one. If the circuit is not as specified, inspect the circuits connected to other parts.

4. INSTALL BLOWER MOTOR LINEAR CONTROLLER
a. Install the blower motor linear controller with the 2 screws.
b. Connect the connector.

5. INSTALL GLOVE COMPARTMENT PARTS