Sliding Roof (TMMK Made)

REMOVAL
1. REMOVE ROOF HEADLINING
2. REMOVE SIDE GARNISHES

HINT: At the time of installation, please refer to the following item. Soak the garnishes in water to soften them before assembly.





3. REMOVE GLASS PANEL ASSEMBLY
a. Remove the 4 glass panel adjustment screws.

HINT: At the time of installation, please refer to the following item. Adjust the height of the glass panel, then tighten the 4 screws.

b. Pull the glass upward to remove it.

4. REMOVE SLIDING ROOF ASSEMBLY




a. Remove the 4 drain hoses from the sliding roof assembly.
b. Remove the 8 bolts and 4 brackets.

Torque: 5.5 N.m (55 kgf.cm, 49 in.lbf)

c. Remove the 6 nuts and the sliding roof assembly.

INSTALLATION
Installation is in the reverse order of removal.

NOTE: Check and adjust the sliding roof after installation.