TMMK Made
Side Airbag Assembly (TMMK Made):
COMPONENTS
REMOVAL
NOTE:
- If the wiring connector of the SRS is disconnected and the ignition switch is at ON or ACC position, DTCs will be recorded.
- Never use the airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. REMOVE FRONT SEAT
a. Remove the 2 seat track covers and 4 bolts.
b. Power adjuster type:
Disconnect the power seat and side airbag connectors.
c. Manual adjuster type:
Disconnect the side airbag connector.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
d. Remove the front seat.
NOTE: Be careful not to damage the body.
2. REMOVE FRONT SEAT CUSHION LOWER SHIELD
3. Manual adjuster type:
REMOVE RELEASE HANDLE
4. Manual adjuster type:
REMOVE VERTICAL ADJUSTER KNOB
5. Power adjuster type:
DISCONNECT CONNECTOR
Disconnect the connector from the power seat switch.
6. REMOVE FRONT SEAT CUSHION SHIELD
7. REMOVE SEATBACK ASSEMBLY
a. Remove the 4 bolts.
b. Remove the hog rings.
c. Disconnect the side airbag connector of the side airbag assembly side.
d. Remove the side airbag sub wire harness after removing clips.
e. Remove the seatback assembly.
INSTALLATION
NOTE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. INSTALL SEATBACK ASSEMBLY
a. Install the seatback assembly.
b. Securely fix the side airbag sub wire harness to the seat cushion with clips.
c. Connect the side airbag connector of the side airbag assembly side.
d. Install new hog rings.
HINT: Install the hog rings to prevent wrinkles as little as possible.
e. Install the 4 bolts.
2. INSTALL FRONT SEAT CUSHION SHIELD
3. Manual adjuster type:
INSTALL VERTICAL ADJUSTER KNOB
4. Manual adjuster type:
INSTALL RELEASE HANDLE
5. Power adjuster type:
CONNECT CONNECTOR
Connect the connector to the power seat switch.
6. INSTALL FRONT SEAT CUSHION LOWER SHIELD
7. INSTALL HEADREST SUPPORT
8. INSTALL HEADREST
9. INSTALL FRONT SEAT
a. Slide the front seat to the most front position.
NOTE: Make sure that seat adjuster locks.
b. Without holding the seat track handle, mount the seat to the vehicle.
HINT: If holding the seat track handle, the adjusted most front position will slip off.
c. Tighten the bolts on the rear side temporarily, starting from the bolt on the inner side tighten them completely.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
d. Slide the seat to the rearmost position to install the bolts on the front side.
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
e. Power adjuster type:
Connect the side airbag connector and power seat connector.
f. Manual adjuster type:
Connect the side airbag connector