Disassembly and Reassembly

DISASSEMBLY

w/ ABS:
REMOVE ABS SPEED SENSOR
(a) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST 09520-00031 (09520-00040, 09521-00020)





(b) Mount the axle hub assembly in a soft jaw vise.

NOTICE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.

(c) Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the ABS speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020

NOTICE:
^ Do not allow any foreign matter sticking to the sensor rotor.
^ Pull out the ABS speed sensor straightly not to damage the sensor rotor.
^ If damage has occurred to the sensor rotor, replace the axle hub assembly.
^ Do not scratch the contacting surface of the axle hub and speed sensor.

REASSEMBLY
w/ ABS:
INSTALL NEW ABS SPEED SENSOR
(a) Clean the contacting surface of the axle hub and a new ABS speed sensor.

NOTICE: Do not allow any foreign matter sticking to the sensor rotor.

(b) Place the ABS speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.





(c) Using SST and a press, install a new ABS speed sensor to the axle hub.
SST 09210-76011

NOTICE:
^ Do not tap the speed sensor with a hammer directly.
^ Check that there should be no foreign matter on the speed sensor detection portion.
^ Press in the ABS speed sensor straightly and slowly.