Wiper and Washer Systems: Service and Repair

REMOVAL




1. REMOVE WIPER ARMS
2. REMOVE HOOD TO COWL TOP SEAL
3. REMOVE COWL LOUVER
4. REMOVE WIPER MOTOR ASSEMBLY
a. Disconnect the connector.
b. Unfasten the 4 bolts and remove the wiper motor assembly.

5. REMOVE WIPER LINK ASSEMBLY
Remove the 6 bolts and wiper link.

6. REMOVE WINDOW WASHER NOZZLE




a. Remove the hose from the nozzle.
b. Using a screwdriver, remove the nozzle.

HINT: Tape the screwdriver tip before use.

c. Employ the same manner described above to the other side.

INSTALLATION

1. INSTALL WINDOW WASHER NOZZLES
2. INSTALL WIPER LINK ASSEMBLY
Install the wiper link with the 6 bolts.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

3. INSTALL WIPER MOTOR ASSEMBLY
a. Fasten the 4 bolts and install the wiper motor assembly.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

b. Connect the connector.

4. INSTALL COWL LOUVER
5. INSTALL HOOD TO COWL TOP SEAL
6. INSTALL WIPER ARMS
a. Install the wiper arms and tighten nuts by hand. Operate the wipers once and turn the wiper switch OFF.




b. Adjust the installation positions of the wiper arms to the positions as shown in the illustration.

"A": 25.0 + 15.0 mm (0.984 + 0.591 in.)

c. Torque the nuts.

Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)