Repair and Diagnosis: Tools and Equipment

FOR USING OBD II SCAN TOOL OR TOYOTA HAND-HELD TESTER

Before using the scan tool or tester, the scan tool's instruction book or tester's operator manual should be read thoroughly.

If the scan tool or tester cannot communicate with ECU controlled systems when you have connected the cable of the scan tool or tester to [1][2]DLC 3, turned the ignition switch ON and operated the scan tool, there is a problem on the vehicle side or tool side.

1. If communication is normal when the tool is connected to another vehicle, inspect the diagnosis data link line (Bus-line) or ECU power circuit of the vehicle.
2. If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tool itself, so perform the Self Test procedures outline in the Tester Operator's Manual.