Airbag Assembly Connectors

DISCONNECTION







a. While holding both flank sides of the outer, slide the outer to the direction shown by an arrow.
b. Lock of the connectors is released, then disconnect the connectors.

HINT: Be sure to hold both flank sides of the outer. If holding the top and bottom sides, it will obstruct disconnection.

CONNECTION

a. Align the male connector (of the side of sensor) and female connector in the same direction as shown in the illustration and fit in them without rubbing.
b. As they are fitted in, the outer slides rearward. Press it until the outer returns to its original position again.
If filling stops half way, connectors will separate.
c. Be sure to insert until they are locked. After filling in, pull them slightly to check that they are locked (When locked, make sure that the outer returns to its original position and the click can be heard at the time of filling in.).






HINT: Do not fit in while holding the outer.When filling in, the outer slides. Do not touch it.