Removal and Installation

Starter (Part 1):

Starter (Part 2):

Starter (Part 3):

REMOVAL
1. REMOVE THROTTLE BODY COVER

2. DISCONNECT ACCELERATOR CABLE

3. REMOVE INTAKE AIR CONNECTOR

4. DISCONNECT THROTTLE BODY ASSEMBLY FROM INTAKE MANIFOLD

5. REMOVE INTAKE MANIFOLD ASSEMBLY

6. REMOVE STARTER




a. Remove the 2 bolts holding the starter to the cylinder block.
b. Disconnect the starter from the cylinder block.




c. Disconnect the starter connector.
d. Remove the nut, bolt and disconnect the starter wire.
e. Remove the bolt, and disconnect the engine wire protector from the starter.
f. Remove the starter.

INSTALLATION
1. INSTALL STARTER




a. Install the engine wire protector to the starter with the bolt.

Torque: 9.81 N.m (100 kgf.cm, 84 in..lbf)

b. Connect the starter wire with the nut.

Torque: 9.81 N.m (100 kgf.cm, 84 in..lbf)

c. Connect the starter connector.
d. Connect the starter to the cylinder block.
e. Connect the engine wire with the bolt.




f. Install the starter with the 2 bolts.

Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)

2. INSTALL INTAKE MANIFOLD ASSEMBLY

3. CONNECT THROTTLE BODY ASSEMBLY TO INTAKE MANIFOLD

4. INSTALL INTAKE AIR CONNECTOR

5. CONNECT ACCELERATOR CABLE

6. INSTALL THROTTLE BODY COVER