Knock Sensor: Testing and Inspection

INSPECTION

1. REMOVE OUTER FR COWL TOP PANEL ASSEMBLY
2. REMOVE AIR CLEANER CAP WITH HOSE
3. REMOVE RH ENGINE MOUNTING STAY
4. REMOVE INTAKE MANIFOLD ASSEMBLY AND WATER OUTLET




5. REMOVE KNOCK SENSORS
a. Disconnect the knock sensor connector.
b. Using SST remove the knock sensor.
SST 09817-16011




6. INSPECT KNOCK SENSORS
Using an ohmmeter, check that there is no continuity between the terminal and body. If there is continuity, replace the sensor.

7. REINSTALL KNOCK SENSORS
a. Using SST, install the knock sensor.
SST 09817-16011

Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)

b. Connect the knock sensor connector.

8. REINSTALL WATER OUTLET AND INTAKE MANIFOLD ASSEMBLY
9. REINSTALL RH ENGINE MOUNTING STAY
10. REINSTALL AIR CLEANER CAP WITH HOSE
11. REINSTALL OUTER FR COWL TOP PANEL ASSEMBLY