Without Differential Lock

REMOVAL









HINT: Pre runner is the model described.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, PZN196L-PRPDKAB, VZN195L-CRPDKAB, VZN195L-PRPDKAB

1. DRAIN HYPOID GEAR OIL
2. REMOVE REAR AXLE SHAFTS
3. DISCONNECT REAR PROPELLER SHAFT
2WD: See Propeller Shaft; Service and Repair.
4WD and pre runner: See Propeller Shaft; Service and Repair.
4. REMOVE DIFFERENTIAL CARRIER ASSEMBLY
a. Remove the 10 nuts, washers and differential carrier assembly.

NOTICE: Be careful not to damage the installation surface.

Torque: 73 Nm (740 kgf-cm, 54 ft. lbs.)
b. Remove the gasket.

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, fill the differential with hypoid gear oil.