Without Scan Tool

DTC CLEARANCE (Using service wire)
a. Using SST, connect the terminal TC and terminal CG of the DLC3. SST 09084-18040

b. Disconnect the terminal TC of DLC3 within 10 seconds after the DTCs appear, and check if the warning light comes on within 3.0 seconds.

c. Within 2.0 seconds to 4.0 seconds after the SRS warning light comes on, reconnect the terminal TC and terminal CG of the DLC3.

d. The SRS warning light goes off 3.0 seconds after reconnecting the terminal TC and terminal CG of the DLC3. Then disconnect the terminal TC of the DLC3 within 2.0 to 4.0 seconds after the SRS warn

e. The SRS warning light comes on within 3.0 seconds after redisconnecting the terminal TC and terminal CG of the DLC3.

f. Within 2.0 seconds to 4.0 seconds after the SRS warning light comes on, re-connect the terminal TC and terminal CG of the DLC3.

g. The SRS warning light goes off 3.0 seconds after reconnecting the terminal TC and terminal CG of the DLC3.

h. A normal code appears 1.0 second after the SRS warning light goes off.
It DTCs are to cleared, repeat the above procedure until the codes are cleared.