Keyless Entry Transmitter: Testing and Inspection

INSPECT WIRELESS DOOR LOCK TRANSMITTER OPERATION

HINT: Refer to "Wireless door look control receiver and transmitter replacement".

a. Using a screwdriver, remove the cover.
b. Remove the battery (lithium battery).




c. Install a new or normal battery (lithium battery).

HINT:
When a new or normal battery can not be obtained, connect 2 new 1.5 V batteries in series. Connect the battery positive (+) to the battery receptacle side terminal and the battery negative (-) to the bottom terminal, then apply 3 V voltage to the transmitter.

d. In the location which is approximately 1 M away from the driver's outside handle in the right direction, check the transmitter operation when pressing the transmission switch on the side of the transmitter body.

Standard:
Remote control of vehicle door lock can be operated.

HINT:
- The minimum operation distance differs according to operator, the way of holding, and location.
- As weak wave is used, operation distance might be shortened when noise is detected in strong wave or used frequency.

e. Install the battery (lithium battery).
f. Install a cover, not to distort or slip off the rubber cover.