Side Airbag Sensor Assembly

Side Airbag Sensor Assy RH:

REPLACEMENT

1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE FRONT DOOR SCUFF PLATE RH
4. REMOVE REAR DOOR SCUFF PLATE RH
5. REMOVE FRONT DOOR OPENING TRIM RH
6. REMOVE REAR DOOR OPENING TRIM RH
7. REMOVE LAP BELT OUTER ANCHOR COVER
8. REMOVE CENTER PILLAR GARNISH LOWER RH
9. REMOVE FRONT SEAT OUTER BELT ASSY RH




10. REMOVE SIDE AIR BAG SENSOR ASSY RH
a. Disconnect the connector from the side airbag sensor assy RH.
b. Remove the 2 nuts and side airbag sensor assy RH.

11. INSPECT SIDE AIR BAG SENSOR ASSY RH
12. INSTALL SIDE AIR BAG SENSOR ASSY RH
a. Install the 2 nuts and side airbag sensor assy RH.

Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)

b. Connect the side airbag sensor connector.

NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure that the sensor assembly is installed to the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.

13. INSTALL FRONT SEAT OUTER BELT ASSY RH

Torque:
Upper bolt: 4.9 Nm (50 kgf.cm, 43 in.lbf)
Lower bolt: 41.2 Nm (420 kgf.cm, 30 ft.lbf)

14. INSTALL SRS WARNING LIGHT