Rear Door: Adjustments
ADJUSTMENTHINT: In the RH side, work in the same procedure as in the LH side.
HINT: Since the centering bolt is used as a door hinge body side set bolt and door hinge door side set bolt, the door can not be adjusted with it on. Substitute a bolt with washer for the centering bolt.
1. ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH
a. Check that the clearance is within the standard value.
2. ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH
a. Adjust the door by loosening the body side hinge nuts.
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)
b. Adjust the door by loosening the door side hinge bolts.
Torque: 27 N.m (275 kgf.cm, 20 ft.lbf)
c. Adjust the striker position by slightly loosening the striker mounting screws, and hitting the striker with a plastic hammer.
d. Tighten the striker mounting screws again.
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)