Rear Axle Hub & Bearing LH Replacement
REPLACEMENT1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
a. Remove the 2 bolts, separate the rear disc brake caliper assy LH.
3. REMOVE REAR DISC (DISC REAR BRAKE TYPE)
4. REMOVE REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
5. DISCONNECT SKID CONTROL SENSOR WIRE (W/ ABS)
6. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and hub & bearing assy LH.
7. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the hub & bearing assy LH with the 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft. lbs.)
8. CONNECT SKID CONTROL SENSOR WIRE (W/ ABS)
NOTICE: Do not twist the sensor wire when connecting it.
9. INSPECT BEARING BACKLASH
a. Using a dial indicator, check the backlash near the center of the axle hub.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy.
10. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy.
11. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
12. INSTALL REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
a. Install the rear disc brake caliper assy LH with 2 bolts.
Torque: 47 Nm (479 kgf-cm, 35 ft. lbs.)
13. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. CHECK ABS SPEED SENSOR SIGNAL (W/ ABS)