Body - Front/Rear Door Glass Run Loose/Deformed

BODY
BO013-03

May 16, 2003

Title:
DOOR GLASS WINDOW RUN IMPROVEMENT

Models:
'03 Matrix

Introduction

Some customers may experience a loose or deformed front or rear door glass window run. Parts have been improved to resolve this condition.

Applicable Vehicles
^ 2003 model year Matrix vehicles produced before the VIN shown below.





Production Change Information





Parts Information





Required Tools & Material





Warranty Information

Applicable Warranty *:

This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle's in-service date.

* Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Front Door

Repair Procedure

If the Front Door Glass Run is Deformed:

1. Place window in down position.





2. Remove Power Window Regulator Switch Assembly (W/Power Window).





3. Remove Front Door Window Regulator Handle Assembly (W/O Power Window).

A. Using a shop rag, remove snap ring.

B. Remove the front door window regulator handle and plate.





4. Remove Front Door Pull Handle.

5. Lift access cover and remove attaching screw from the Door Inside Handle Sub-Assembly.





6. Remove Front Door Lower Frame Bracket Garnish.





7. Remove Front Door Trim Board Sub-Assembly (see diagram for clip location).

8. Remove Door Glass Window Run.

9. Install New Door Glass Window Run.

10. Reassemble in reverse order.

NOTE:
Please refer to the 2003 Matrix Repair Manual Vol. 2, pg. 75-5 for additional information.

Rear Door

Repair Procedure

If the Rear Door Glass Run is Deformed:

1. Place window in down position.





2. Remove Rear Door Window Regulator Handle Assembly (W/O Power Window).

A. Using a shop rag, remove snap ring.

B. Remove the rear door window regulator handle and plate.





3. Remove Rear Door Pull Handle.

4. Lift access cover and remove attaching screw from the Door Inside Handle Sub-Assembly.





5. Remove Rear Door Trim Board Sub-Assembly (see diagram for clip location).

6. Remove Door Glass Window Run.

7. Install New Door Glass Window Run.

8. Reassemble in reverse order.

NOTE:
Please refer to the 2003 Matrix Repair Manual, Vol. 2, pg. 75-18 for additional information.

If the Door Glass Run is loose:

Carefully reattach it using 3M Super Weatherstrip Adhesive, or equivalent.