Exhaust System - Tailpipe Joint Clamp Installation
PRODUCT GENERAL INFORMATIONPG003-05
March 14, 2005
Title:
EXHAUST TAILPIPE JOINT CLAMP INSTALLATION
Models:
Applicable Models
Introduction
The purpose of this bulletin is to provide additional details regarding the proper installation angle of an exhaust tailpipe joint clamp on applicable Toyota vehicles.
Applicable Vehicles
^ 2003 - 2005 model year Corolla vehicles.
^ 2000 - 2005 model year ECHO vehicles.
^ 2004 - 2005 model year Land Cruiser vehicles.
^ 2003 - 2005 model year Matrix vehicles.
^ 2001 - 2003 model year Prius vehicles.
^ 2004 - 2005 model year Sequoia vehicles.
^ 2004 - 2005 model year Scion xA vehicles.
^ 2004 - 2005 model year Scion xB vehicles.
^ 2003 - 2005 model year Tundra vehicles.
Warranty Information
Installation Procedure
All Models:
Install exhaust tailpipe assembly.
1. Install a new gasket into the exhaust center pipe.
2. Install the new clamp positioning the bolt within the acceptable range" shown in the corresponding illustrations.
NOTE:
Do not reuse the removed gasket and clamp.
2003 - 2005 Corolla:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)
2000 - 2005 ECHO,
2004 - 2005 Scion xA & xB:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)
2004 - 2005 Land Cruiser:
Torque: 35 Nm (357 kgf.cm, 26 ft.lbf)
2003 - 2005 Matrix:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)
2001 - 2003 Prius:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)
2004 - 2005 Sequoia:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)
2003 - 2005 Tundra:
Torque: 32 Nm (326 kgf.cm, 24 ft.lbf)