Initial Inspection
ON-VEHICLE INSPECTION1. INSPECT TURN SIGNAL FLASHER CIRCUIT
a. Disconnect the connector from the turn signal flasher and inspect the connector on wire harness side as shown in the chart.
b. Connect the connector to the turn signal flasher and inspect the wire harness side connector from the back side as shown in the chart.
2. INSPECT DAYTIME RUNNING LIGHT MAIN RELAY CIRCUIT
a. Disconnect the connector from the relay and inspect the connector on the wire harness side.
If circuit is specified, try replacing the relay with a new one.
If circuit is not as specified, inspect the circuits connected to other parts.
3. ILLUMINATED ENTRY SYSTEM OPERATION CHECK
HINT: The lights that is lit in the illuminated entry system are room lamp assy No.1 (center and rear) and key cylinder lamp.
a. Turn the ignition switch to OFF close all the doors, and set the driver side door in the lock condition.
b. Unlock the driver side door and open any door; and check that the lights go on. Close the door and check that the lights go off in about 15 seconds.
c. Turn the ignition switch to ON and open and close any door. Check that the light goes off immediately.
d. Turn the ignition switch to OFF.
e. Open and close any door to turn on the lights. Before the lights go off in about 15 seconds, turn the ignition switch to ON. Check that the lights go off immediately.
f. Turn the ignition switch to OFF.
g. Open and close any door to turn on the lights. Before the lights go off in about 15 seconds, lock the driver side door. Check that the lights go off immediately.