Component Tests

INSPECTION







1. INSPECT SLIDING ROOF CONTROL SWITCH
If continuity is not as specified, replace the switch.







2. INSPECT SLIDING ROOF CONTROL RELAY CIRCUIT
Disconnect the connector from the relay and switch and inspect the connector on the wire harness side, as shown in the table.

3. INSPECT SLIDING ROOF MOTOR CIRCUIT BREAKER OPERATION




a. With the sliding roof in the fully opened position, hold the sliding roof switch in "SLIDE OPEN" position and check that there is a circuit breaker operation noise within 10 to 60 seconds.




b. With the sliding roof in the fully opened position, hold the sliding roof switch in "TILT UP" position and check that the sliding roof begins to close within 60 seconds.
If operation is not as specified, replace the motor.