Front Wiper and Washer
REMOVAL1. REMOVE WIPER ARM HEAD CAPS AND FRONT WIPER ARMS
2. REMOVE COWL TOP VENTILATOR LOUVER AND HOOD TO COWL TOP SEAL
3. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
a. Disconnect the connector, then unfasten the 3 bolts.
b. Remove the wiper motor and link assembly.
INSTALLATION
1. INSTALL WIPER MOTOR AND LINK ASSEMBLY
a. Install the wiper motor and link assembly, then torque the 3 bolts.
Torque: 7.0 N.m (70 kgf.cm, 62 in.lbf)
b. Connect the connector.
2. INSTALL COWL TOP VENTILATOR LOUVER AND HOOD TO COWL TOP SEAL
3. INSTALL WIPER ARMS
a. Operate the wipers once and turn the wiper switch OFF.
b. Install the wiper arms and torque the 2 nuts by hand.
c. Adjust the installation positions of the wiper arms to the positions as shown in the illustration.
A: Approx. 25 mm (0.98 in.)
B: Approx. 30 mm (1.18 in.)
d. Torque the 2 nuts.
Torque: 25 N.m (255 kgf.cm, 18 ft.lbf)
e. Install the wiper arm head caps.