Engine Lubrication: Service and Repair

REPLACEMENT

CAUTION:
- Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
- Care should be taken, therefore, when changing engine, oil to minimize the frequency and length of time your skin is exposed to used engine oil. Protective clothing and gloves that cannot be penetrated by oil should be worn. The skin should be thoroughly washed with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
- In order to preserve the environment, used oil and used oil filters must be disposed of only at designated disposal sites.





1. DRAIN ENGINE OIL
a. Remove the oil filler cap.
b. Remove the oil dipstick.
c. Remove the oil drain plug and drain the oil into a container.





2. REPLACE OIL FILTER
a. Using SST, remove the oil filter (located on left side of the cylinder block)
SST 09228-07501
b. Clean the filter contact surface on the filter mounting
c. Apply clean engine oil to the gasket of a new oil filter
d. Tighten the filter by hand until the gasket contacts the seat of the filter mounting. Then using SST, give it an additional 3/4 turn to seat the filter.
SST 09228-07501
3. REFILL WITH ENGINE OIL
a. Clean and install the oil drain plug with a new gasket.
b. Fill the engine with new oil.





Oil capacity

c. Reinstall the oil filler cap.
4. START ENGINE AND CHECK FOR LEAKS
5. RECHECK ENGINE LEVEL