Restraints and Safety Systems: Service Precautions

NOTE: When inspecting or repairing the SRS, perform the operation in accordance with the following precautionary instructions and the procedure and precautions for the applicable model year.

- Malfunction symptoms of the SRS are difficult to confirm, so the DTCs become the most important source of information when troubleshooting. When troubleshooting the SRS, always inspect the DTCs before disconnecting the battery.

- Work must be started after 90 seconds from when the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source so that if work is started within 90 seconds from disconnecting the negative (-) terminal cable of the battery, the SRS may be deployed.)

- When the negative (-) terminal cable is disconnected from the battery, the memory of the clock and audio system will be canceled. So before starting work, make a record of the contents memorized in the audio memory system. When work is finished, reset the audio systems as they were before and adjust the clock. To avoid erasing the memory in each memory system, never use a back-up power supply from outside the vehicle.

- Before repairs, remove the airbag sensor if shocks are likely to be applied to the sensor during repairs.

- Do not expose the steering wheel pad, front passenger airbag assembly, seat belt pretensioner, center airbag sensor assembly or front airbag sensor assembly directly to hot air or flames.

- Even in cases of a minor collision where the SRS does not deploy, the steering wheel pad, front passenger airbag assembly, seat belt pretensioner, center airbag sensor assembly and front airbag sensor assembly should be inspected.

- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.

- Never disassemble and repair the steering wheel pad, front passenger airbag assembly, seat belt pretensioner, center airbag sensor assembly or front airbag sensor assembly in order to reuse it.

- If the steering wheel pad, front passenger airbag assembly, seat belt pretensioner, center airbag sensor assembly or front airbag sensor assembly has been dropped, or if there are cracks, dents or other defects in the case, bracket or connector, replace them with new ones.

- Use a volt/ohmmeter with high impedance (10 kOhms/V minimum) for troubleshooting the system's electrical circuits.

- Information labels are attached to the periphery of the SRS components. Follow the instructions on the notices.

- After work on the SRS is completed, perform the SRS warning light check.

- If the vehicle is equipped with a mobile communication system, refer to the applicable precautions.