Programming and Relearning

REGISTRATION PROCEDURE

REGISTER RECOGNITION CODE

HINT:
- The add mode is used to retain the registered recognition codes while a new recognition code is additionally registered. This mode is used when a new transmitter is added. If the number of the registered codes exceeds 4, the registered codes will be correspondingly erased in order, starting from the oldest code.
- The rewrite mode is used to erase all the registered recognition codes and register only new recognition codes. This mode is used when the transmitter or the door control receiver is exchanged for new one.
- The erase mode is used to erase all the registered recognition codes and cancel the wireless door lock function. This mode is used when the transmitter is lost.
- The synchronization mode is used to renew the sequential code (rolling code) of the transmitter and synchronize it with the registered recognition code. This mode is used when the transmitter does not function because they are unsynchronized.*1 Up to 4 transmitters can be synchronized at one time.
- The setting mode is used to set the optional operation via the transmitter that has the recognition code already registered. 2-unlock operation*2 is available as the option. The setting of up to 4 transmitters can be changed at one time.
- All the following registration procedures must be performed in order continuously.

*1: If a switch on the transmitter is pressed while out of range of the TVIP ECU, the system will not be able to synchronize the sequential code (rolling code) with the registered recognition code. At this time, the system will automatically synchronize them; however automatic synchronization can be performed only 500 times. Therefore, it is necessary to use this mode after they have synchronized 500 times
*2: 2 unlock operation is a operation to unlock the door: when the UNLOCK switch is pressed once, only the driver's door will be unlocked; and when the UNLOCK switch is pressed again within 3 seconds, the other doors will be unlocked.