Transfer Removal

TRANSFER UNIT

HINT: VF2BM transfer is used for the vehicles with 2UZ-FE engine installed.

REMOVAL

HINT: Turn the touch select 2-4 switch ON.

1. DISCONNECT BREATHER HOSE
Disconnect the breather hose from the transfer.
2. RAISE VEHICLE AND DRAIN TRANSFER OIL
3. REMOVE LH AND RH FRONT EXHAUST PIPES
4. REMOVE FRONT AND REAR PROPELLER SHAFTS





5. REMOVE CROSSMEMBER
a. Support the transmission rear side with a transmission jack.
b. Remove the 4 bolts.
c. Remove the 4 bolts, nuts and crossmember.
6. REMOVE ENGINE REAR MOUNTING
Remove the 4 bolts and engine rear mounting from the transfer adaptor.
7. DISCONNECT VEHICLE SPEED SENSOR, TRANSFER DETECTION SWITCHES AND MOTOR ACTUATOR CONNECTORS





8. REMOVE TRANSFER
a. Support the transfer with another transmission jack.
b. Remove the 8 transfer mounting bolts.
c. Pull out the transfer from the transfer adaptor down and toward the rear.