Rear Wheel Alignment

NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).

REAR WHEEL ALIGNMENT
INSPECTION
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT

NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified valve.





3. INSPECT TOE-IN








Toe-in

If the toe-in is not within the specified value, inspect the suspension parts and replace them if necessary.
4. INSPECT CAMBER
a. Install the camber-caster-kingpin gauge or position the vehicle on the wheel alignment tester.
b. Inspect the camber.








Camber

If the measured valve is not within the specified value, inspect the suspension parts for damage and/or wear and replace them if necessary because camber is not adjustable.