Removal and Installation of Fuel Control Parts

REMOVAL AND INSTALLATION OF FUEL CONTROL PARTS

a. PLACE FOR REMOVING AND INSTALLING OF FUEL SYSTEM PARTS
1. Work in a place with good air ventilation and without any ignition sources, such as a welder, grinder, drill, electric motor or stove.
2. Never work in a place such as a pit or near a pit because vaporized fuel will collect in those places.

b. REMOVING AND INSTALLING OF FUEL SYSTEM PARTS
1. Prepare a fire extinguisher before starting operation.
2. To prevent static electricity, install a ground on the fuel changer, vehicle and fuel tank, and do not spray the area with water. The work surface will become slippery. Do not clean up spills with water as this will spread gasoline and create a fire hazard.
3. Never use any electric equipment like an electric motor or a working light, as they may create sparks or high temperatures.
4. Never use an iron hammer, as it may create sparks.
5. Dispose of fuel-contaminated cloth separately using a fire resistant container.