Crankshaft Position Sensor: Service and Repair
REPLACEMENT1. REMOVE GENERATOR ASSEMBLY
2. REMOVE ENGINE UNDER COVER ASSEMBLY REAR
a. Remove the 4 bolts and the engine under cover assembly rear.
3. SEPARATE COOLER COMPRESSOR ASSEMBLY
a. Remove the bolt and separate the suction hose sub- assembly.
b. Disconnect the cooler compressor assembly connector.
c. Remove the 4 bolts and separate cooler compressor assembly from the V-ribbed belt tensioner assembly.
4. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt and the crankshaft position sensor.
5. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to an O-ring of the crankshaft position sensor.
b. Install the crankshaft position sensor with the bolt.
Torque: 10 Nm (102 kgf.cm, 7 ft.lbf)
c. Connect the crankshaft position sensor connector.
6. INSTALL COOLER COMPRESSOR ASSEMBLY
a. Install the cooler compressor assembly with the 4 bolts.
Torque: 25 Nm (255 kgf.cm, 18 ft.lbf)
b. Connect the cooler compressor assembly connector.
c. Install the suction hose sub-assembly with the bolt.
Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)
7. INSTALL ENGINE UNDER COVER ASSEMBLY REAR
a. Install the engine under cover assembly rear with the 4 bolts.
Torque: 29 Nm (296 kgf.cm, 21 ft.lbf)
8. INSTALL GENERATOR ASSEMBLY