Engine Control Module: Service and Repair
REPLACEMENT1. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2
2. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY
3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2
4. REMOVE ECM
a. Disconnect the 5 the ECM connectors from the ECM.
b. Remove the 3 nuts and the ECM.
c. Remove the 2 screws and the ECM bracket No. 1 from the ECM.
d. Remove the 2 screws and the ECM bracket No. 2 from the ECM.
5. INSTALL ECM
a. Install the ECM bracket No. 2 with the 2 screws to the ECM.
b. Install the ECM bracket No. 1 with the 2 screws to the ECM.
c. Install the ECM with the 3 nuts.
Torque: 13 Nm (133 kgf.cm, 10 ft.lbf)
d. Connect the 5 ECM connectors to the ECM.