Body - Power Moonroof Initialization Procedure

PRE-DELIVERY SERVICE
PD045-04

Title:
INITIALIZATION OF MOON ROOF

Models:
'05 Sienna

October 14, 2004

Introduction

As a result of the removal of the Short Pin, the "one-touch tilt up and down," "one-touch slide open and close," and "jam protection" functions of the Moon Roof will be inoperative due to loss of the Moon Roof position memory stored in the microcomputer.

Therefore, please initialize the Moon Roof after installing the Short Pin in its original location during Pre-Delivery Service (PDS) at the dealership.

NOTE:
Any time the battery terminal has been disconnected, initialize the Moon Roof after reconnecting the battery terminal.

Applicable Vehicles

2005 model year Sienna vehicles.

Initialization Procedure

With ignition switch in the "ON" position, do the following:





1. Push and hold the "TILT UP" side of the switch until the Moon Roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.4 in.] at rear end).

2. Check for proper operation of the "One-touch slide open/close" and "One-touch tilt up/down" functions by pushing the switch briefly to the "SLIDE OPEN" and "TILT UP" positions.

NOTE:
Jam protection function becomes effective through the above initialization procedure.





Warranty Information