Without Scan Tool

DTC CHECK (USING SST CHECK WIRE)

Checking DTCs using a SST check wire.

SST 09843-18040




1. Using SST, connect terminal Tc and CG of the DLC3.
2. Turn the ignition switch ON.




3. Read the DTC from the ABS warning light on the combination meter.

HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.
- As an example, the blinking patterns for normal code and codes 11 and 21 are shown.

4. Codes are explained in the code table.

If 2 or more DTCs are detected at the same time, the lowest numbered DTC is displayed 1st.

5. After completing the check, remove the SST from the DLC3.