Rear Right Sensor

Air Bag Sensor Rear RH:

REPLACEMENT

HINT: Replacement procedure of the LH side is the same as that of the RH side except for step 9.

1. PRECAUTION
Observe Air Bag Systems; Service Precautions.

2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE REAR DOOR SCUFF PLATE RH
4. REMOVE REAR DOOR WEATHERSTRIP RH
5. REMOVE BACK DOOR WEATHERSTRIP
6. REMOVE BACK DOOR SCUFF PLATE
7. REMOVE LAP BELT OUTER ANCHOR COVER REAR NO.2 SEAT
8. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT RH
9. REMOVE AIR DUCT ASSEMBLY
a. Remove the screw and the air duct assembly.




10. REMOVE AIR BAG SENSOR REAR RH
a. Disconnect the connector of the airbag sensor rear RH.
b. Remove the 2 bolts and the airbag sensor rear RH.

11. INSTALL AIR BAG SENSOR REAR RH
a. Check that the ignition switch is OFF.
b. Check that the battery negative (-) terminal is disconnected.

NOTE: Do not start the operation for 90 seconds after removing the terminal.

c. Install the airbag sensor rear RH with the 2 bolts.

Torque: 17.5 N.m (178 kgf.cm, 13 ft.lbf)

NOTE:
- Installation of the connector is performed with the airbag sensor rear RH installed. Make sure the airbag sensor rear RH is installed with the specified torque.
- If the airbag sensor rear RH has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the airbag sensor rear RH with a new one.
- When installing the airbag sensor rear RH, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.

d. Connect the connector of the airbag sensor rear RH.
e. Check that no play is identified.

12. INSPECT SRS WARNING LIGHT