Programming and Relearning

PRECAUTION

1. INITIALIZATION

NOTE:
- Perform the AT initialization when replacing the automatic transmission assembly, engine assembly or ECM.
- Perform the REGISTRATION (VIN registration) when replacing the ECM.

HINT: Initialization can be completed by only disconnecting the battery terminal.

2. FOR USING HAND-HELD TESTER

CAUTION: Observe the following instructions for safety reasons:
- Read its instruction books before using the tester.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.

3. CONNECT BATTERY NEGATIVE TERMINAL
a. Connect the battery negative terminal to the cable and run the engine at no less than 2,000 rpm for 1 minute.

NOTE: If the engine exceeds 2,000 rpm, the clutch is automatically disengaged by the compressor protection control system.