Ignition Switch: Service and Repair

IGNITION OR STARTER SWITCH ASSEMBLY

REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL




2. REMOVE STEERING COLUMN COVER LWR
a. Remove the 2 screws.
b. Disengage the 2 claws and remove the steering column cover LWR.




3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY
a. Disconnect the connector.
b. Disengage the 2 clamps, then remove the ignition or starter switch.

4. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
5. INSTALL STEERING COLUMN COVER LWR
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)