Acceleration/Deceleration Sensor: Service and Repair

DECELERATION SENSOR (W/O VSC FOR 4WD AND PRE RUNNER)

REPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT SEAT ASSEMBLY (BENCH SEAT TYPE)
3. REMOVE FRONT SEAT ASSEMBLY LH (SEPARATE SEAT TYPE)
4. REMOVE FRONT FLOOR FOOTREST
5. REMOVE FRONT DOOR SCUFF PLATE LH
6. REMOVE COWL SIDE TRIM BOARD LH
7. REMOVE SENSOR BRACKET
a. Turn up the floor carpet.





b. Remove the wire harness clamp.
c. Remove the bolt and bracket.





8. REMOVE DECELERATION SENSOR
a. Disconnect the deceleration sensor connector.
b. Remove the 2 bolts and deceleration sensor.





9. INSTALL DECELERATION SENSOR
a. Install the deceleration sensor with the 2 bolts.
Torque: 12.5 Nm (127 kgf-cm, 9 ft. lbs.)

NOTICE: Make sure the sensor is at the correct angle when installing.

b. Connect the deceleration sensor connector.





10. INSTALL SENSOR BRACKET
a. Install the bracket with the bolt.
Torque: 12.5 Nm (127 kgf-cm, 9 ft. lbs.)
b. Install the wire harness clamp.
11. INSTALL COWL SIDE TRIM BOARD LH
12. INSTALL FRONT DOOR SCUFF PLATE LH
13. INSTALL FRONT FLOOR FOOTREST
14. INSTALL FRONT SEAT ASSEMBLY (BENCH SEAT TYPE)
15. INSTALL FRONT SEAT ASSEMBLY LH (SEPARATE SEAT TYPE)
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
17. CHECK ABS SENSOR SIGNAL