Precaution

PRECAUTION

1. INITIALIZATION

NOTE:
- When disconnecting the negative (-) battery terminal, initialize the following system after the terminal is reconnected.
Power Window Control
Sliding Roof System

- Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
- Perform the REGISTRATION (VIN registration) when replacing the ECM.

HINT: Initialization can not be completed by only removing the battery.

2. FOR USING HAND-HELD TESTER

CAUTION: Observe the following items for safety reasons:

- Read its instruction books before using the tester.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.




3. EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications of the vehicle.

The expressions listed in the table are used.

4. FOR USING BATTERY DURING INSPECTION
While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.