Parking Brake System: Adjustments
PARKING BRAKE SYSTEMADJUSTMENT
1. REMOVE REAR WHEEL
2. ADJUST PARKING BRAKE SHOE CLEARANCE
a) Temporarily install the hub nuts.
b) Remove the shoe adjusting hole plug.
c) Turn the shoe adjuster and expand the shoe until the disc locks.
d) Turn and contract the shoe adjuster until the disc can rotate smoothly
Standard: Return 8 notches
e) Check that there is no brake drag against the shoe.
f) Install the shoe adjusting hole plug.
g) Remove the hub nuts.
3. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
4. INSPECT PARKING BRAKE PEDAL TRAVEL
a) Fully depress the parking brake pedal and release it to engage the parking brake.
b) Depress the pedal to the floor again, and release it to disengage the parking brake.
c) Slowly depress the parking brake pedal to the floor, and count the number of clicks.
Standard: 5 to 7 notches at 300 N (31 kgf, 68.3 ft. lbs.)
5. ADJUST PARKING BRAKE PEDAL TRAVEL
a) Depress the parking brake pedal. Hold the wire adjusting No.1 nut using a wrench and loosen the lock nut.
b) Release the parking brake pedal.
c) Turn the wire adjusting No.1 nut until the parking brake pedal travel meets the standard.
d) Hold the wire adjusting No.1 nut using a wrench or equivalent tool and tighten the lock nut.
Torque: 6.0 Nm (61 kgf-cm, 53 inch lbs.)
e) Count the number of clicks after depressing and releasing the parking brake pedal 3 or 4 times.
f) Check whether the parking brake drags.
g) When operating the parking brake pedal, check that the parking brake indicator light comes on.