Removal and Installation
FRONT BRAKECOMPONENTS:
REMOVAL
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTICE: Wash the brake fluid off immediately if it adheres to any painted surfaces.
3. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH
a. Remove the union bolt and gasket from the disc brake cylinder sub-assembly, then disconnect the flexible hose.
b. Remove the 2 bolts and disc brake cylinder subassembly.
INSTALLATION
1. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
a. Install the disc brake cylinder assembly LH with the 2 bolts
Torque: 34 Nm (350 kgf-cm, 25 ft. lbs.)
2. CONNECT FRONT FLEXIBLE HOSE
a. Connect the flexible hose with the union bolt and a new gasket.
Torque: 29 Nm (300 kgf-cm, 21 ft. lbs.)
NOTICE: Install the flexible hose lock securely in the lock hole in the disc brake cylinder sub-assembly.
3. FILL RESERVOIR WITH BRAKE FLUID
4. BLEED MASTER CYLINDER
5. BLEED BRAKE LINE
6. BLEED BRAKE ACTUATOR ASSEMBLY
7. CHECK FLUID LEVEL IN RESERVOIR
8. CHECK BRAKE FLUID LEAKAGE
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)