Component Tests and General Diagnostics
PARKING BRAKE SYSTEMINSPECTION
1. INSPECT BRAKE DISC INSIDE DIAMETER
a. Using a brake drum gauge or equivalent tool, measure the inside diameter of the rear disc.
Standard inside diameter: 190 mm (7.480 inch)
Maximum inside diameter: 191 mm (7.520 inch)
2. INSPECT PARKING BRAKE SHOE LINING THICKNESS
a. Using a ruler, measure the thickness of the shoe lining.
Standard thickness: 2.5 mm (0.098 inch)
Minimum thickness: 1.0 mm (0.039 inch)
If the lining thickness is minimum or less, or if there is severe or uneven wear, replace the brake shoe.
3. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT
a. Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit disc.
If the contact between the brake disc and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.