Removal and Installation
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER
a. Using a moulding remover, disengage the 5 clips.
b. Disconnect the connectors, and remove the instrument panel finish panel lower.
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
a. Using a moulding remover, disengage the 5 clips, and remove the instrument cluster finish panel assembly.
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
a. Remove the 4 screws.
b. Disengage the claw, and remove the instrument cluster finish panel garnish.
5. REMOVE COMBINATION METER ASSEMBLY
a. Remove the 3 screws, and pull the combination meter assembly.
b. Disconnect the connectors.
INSTALLATION
1. INSTALL COMBINATION METER ASSEMBLY
a. Connect the connectors.
b. Install the combination meter assembly with the 3 screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
a. Engage the claw.
b. Install the instrument cluster finish panel garnish with the 4 screws.
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
a. Engage the 5 clips and install the instrument cluster finish panel assembly.
4. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER
a. Connect the connectors.
b. Engage the 5 clips and install the instrument panel finish panel lower.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal.