Removal and Installation
REMOVALHINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read Air Bag Systems; Service Precautions thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY".
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
a. Disconnect the connector from the curtain shield airbag assembly LH.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
b. Remove the 3 clips.
c. Remove the 9 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
a. Install the curtain shield airbag assembly LH with the 9 bolts in the order shown in the illustration.
Torque: 14 N.m (143 kgf.cm, 10 ft.lbf)
NOTE: Do not twist the curtain shield airbag assembly LH when installing it.
b. Install the 3 clips.
c. Connect the connector to the curtain shield airbag assembly LH.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
5. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.