Removal and Installation
REMOVALNOTE: Before changing the starter, check the following again:
- Connector connection
- Accessory installation
1. REMOVE BATTERY
2. REMOVE BATTERY TRAY
3. REMOVE STARTER ASSEMBLY
a. Disconnect the stater connector [A].
b. Open the terminal cap, remove the and disconnect the starter wire [B].
c. Remove the 2 bolts and starter.
INSTALLATION
1. INSTALL STARTER ASSEMBLY
a. Install the starter with the 2 bolts.
Torque: 37 N.m (377 kgf.cm, 27 ft.lbf)
b. Install the terminal nut and cover the nut with the cap [B].
Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf)
c. Connect the starter wire [C].
2. INSTALL BATTERY TRAY
3. INSTALL BATTERY
a. Install the battery clamp with the bolt and nut.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
b. Connect the cables to the battery terminals.
Torque: 3.5 N.m (36 kgf.cm, 31 in.lbf)