Transmission Installation
AUTOMATIC TRANSMISSION ASSEMBLYINSTALLATION
1. CHECK TORQUE CONVERTER INSTALLATION
a. Install the torque converter to the transmission housing.
b. Using vernier calipers and a straight edge, measure dimension A between the transmission fitting part and the converter fitting part of the drive plate.
c. Using vernier calipers and a straight edge, measure the dimension B shown in the illustration and check that B is greater than A measured in step (b).
Standard distance: A + 1 mm (0.04 inch) or more
2. MEASURE DRIVE PLATE RUNOUT AND INSPECT RING GEAR
3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
a. Installation is in the reverse order of removal
HINT:
^ After installation, adjust the shift lever position.
^ Fill with ATF and check the fluid level.
Fluid type: Toyota genuine ATF WS
^ Conduct the road test of the vehicle.