Service Data

Connecting rod
Specified thrust clearance 0.160 to 0.362 mm (0.0083 to 0.0143 inch)
Specified oil clearance 0.024 to 0.080 mm (0.0009 to 0.0031 inch)
Connecting rod bearing center wall thickness (Reference)
Mark 1 1.485 to 1.488 mm (0.0585 to 0.0586 inch)
Mark 2 1.488 to 1.491 mm (0.0586 to 0.0587 inch)
Mark 3 1.491 to 1.494 mm (0.0587 to 0.0588 inch)
Maximum rod out-of-alignment per 100 mm (3.94 inch) 0.05 mm (0.0020 inch)
Maximum rod twist per 100 mm (3.94 inch) 0.15 mm (0.0059 inch)
Connecting rod bolt
Specified diameter 7.0 to 7.3 mm (0.276 to 0.287 inch)

Cylinder block
Maximum warpage 0.05 mm (0.0020 inch)
Specified cylinder bore diameter 88.500 to 88.633 mm (3.4843 to 3.4894 inch)
Cylinder block main journal bore diameter (Reference)
Mark 0 59.000 to 59.002 mm (2.3228 to 2.3229 inch)
Mark 1 59.002 to 59.004 mm (2.3229 to 2.3230 inch)
Mark 3 59.006 to 59.009 mm (2.3231 to 2.3232 inch)
Mark 4 59.009 to 59.011 mm (2.3232 to 2.3233 inch)
Mark 5 59.011 to 59.013 mm (2.3233 to 2.3233 inch)
Mark 6 59.013 to 59.016 mm (2.3233 to 2.3235 inch)
Main journal diameter 54.988 to 55.000 mm (2.1648 to 2.1654 inch)

Specified main journal oil clearance 0.008 to 0.024 mm (0.0031 to 0.00094 inch)
Maximum main journal taper and out-of round 0.003 mm (0.0001 inch)
Crankshaft bearing cap set bolt
Specified diameter 7.2 to 7.6 mm (0.283 to 0.299 inch)

Piston
Piston diameter 88.439 to 88.449 mm (3.4818 to 3.4822 inch)

Piston ring
Ring groove clearance 0.030 to 0.070 mm (0.0012 to 0.0028 inch)
Specified end gap
No.1 0.22 to 0.892 mm (0.0087 to 0.0350 inch)
No.2 0.50 to 1.35 mm (0.0197 to 0.0531 inch)
Oil (side rail) 0.10 to 0.73 mm (0.0039 to 0.0287 inch)