Crankshaft, Engine
CrankshaftMain Journal
Diameter
Except No. 3 59.987 to 60.000 mm (2.3619 to 2.3622 inch)
No. 3 59.981 to 59.994 mm (2.3615 to 2.3620 inch)
Maximum Taper & Out-of-Round 0.005 mm (0.0002 inch)
Maximum Circle Runout 0.03 mm (0.0012 inch)
Crank Pin
Diameter 52.989 to 53.002 mm (2.0862 to 2.0867 inch)
Maximum Taper & Out-of-Round 0.003 mm (0.0001 inch)
Thrust Clearance
Standard 0.020 to 0.220 mm (0.0008 to 0.0087 inch)
Maximum 0.30 mm (0.0118 inch)
Main Bearing Oil Clearance
Standard
No. 3 Journal 0.030 to 0.055 mm (0.0012 to 0.0022 inch)
Others 0.024 to 0.049 mm (0.0009 to 0.0019 inch)
Maximum 0.10 mm (0.0039 inch)
Crankshaft Bearing Cap Bolt Inspection
Standard Diameter 10.76 to 10.97 mm (0.4236 to 0.4319 inch)
Minimum Diameter 10.66 mm (0.4197 inch)
Main Bearing Cap Bolts
First Pass 39 Nm (398 kgf-cm, 29 ft. lbs.)
Cylinder Block Main Journal Bore Diameter:
Standard Bearing Center Wall Thickness:
Main Bearing Size Codes