Cylinder Head Assembly: Specifications
CYLINDER HEADFor tightening specifications and sequences of the cylinder heads, please refer to service procedures provided at Cylinder Head Assembly; Service and Repair. Service and Repair
Maximum warpage: 0.10 mm (0.0039 inch)
CYLINDER HEAD BOLT
Standard outside diameter: 9.810 to 9.960 mm (0.3862 to 0.3921 inch)
Minimum outside diameter: 9.70 mm (0.3819 inch)
INTAKE MANIFOLD
Install and uniformly tighten the 6 bolts and 4 nuts in several steps.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
CAMSHAFT BEARING CAPS
Uniformly tighten the 22 bearing cap bolts in several steps, in the sequence shown.
Torque for bolt C: 7.5 Nm (76 kgf-cm, 66 inch lbs.)
Torque for others: 16 Nm (160 kgf-cm, 12 ft. lbs.)
EXHAUST MANIFOLD RH
Install the exhaust manifold with 8 new nuts. Uniformly tighten the nuts in several steps.
Torque: 44 Nm (450 kgf-cm, 32 ft. lbs.)
EXHAUST MANIFOLD LH
Install the exhaust manifold with 8 new nuts. Uniformly tighten the nuts in several steps.
Torque: 44 Nm (450 kgf-cm, 32 ft. lbs.)