Inspection

INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE (-) BATTERY TERMINAL
2. REMOVE REMOVE GLOVE COMPARTMENT
a. Remove the 2 screws and glove compartment door.
b. Remove the 3 screws and lower No.2 finish panel.

3. REMOVE HEATER TO REGISTER DUCT
4. REMOVE ECM
a. Disconnect the 5 connectors.
b. Remove the 2 bolts and ECM.

5. INSPECT ECM
Refer to Control Module Pinout Values. Pinout Values and Diagnostic Parameters
6. REINSTALL ECM
a. Install the ECM with the 2 bolts.
b. Connect the 5 connectors.

7. INSTALL HEATER TO REGISTER DUCT
8. INSTALL GLOVE COMPARTMENT
a. Install the lower No.2 finish panel with 3 screws.
b. Install the glove compartment door with the 2 screws.

9. CONNECT CABLE TO NEGATIVE (-) BATTERY TERMINAL