Installation

1NZ-FE ENGINE CONTROL SYSTEM: ECM: INSTALLATION

1. INSTALL ECM BRACKET NO. 2





(a) Install ECM bracket No. 2 with the 2 screws.

2. INSTALL ECM BRACKET





(a) Install the ECM bracket with the 2 screws.

3. INSTALL ECM





(a) Install the ECM with the bolt and 2 nuts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the 2 ECM connectors.

(c) Install the 2 lock knobs and harness clamp.





4. INSTALL COWL TOP PANEL OUTER Installation

5. INSTALL COWL TO REGISTER DUCT SUB-ASSEMBLY NO. 2 Installation

6. INSTALL WINDSHIELD WIPER MOTOR AND LINK Installation

7. INSTALL COWL TOP VENTILATOR LOUVER LH Installation

8. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

9. INSTALL HOOD TO COWL TOP SEAL Installation

10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

12. INSTALL FRONT WIPER ARM HEAD CAP Installation

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)