Removal and Replacement

REAR BUMPER

Rear Bumper:

Rear Bumper:

REMOVAL

1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler)






a. Put protective tape around the rear bumper assembly.
b. Using a screwdriver, open the 2 rear bumper plates.






HINT: Tape the screwdriver tip before use.

c. Remove the 6 screws and 2 clips.






d. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.






HINT: Use the same procedures for the RH side and LH side.

e. Remove the rear bumper assembly.

2. REMOVE REAR FLOOR BOARD (w/ Rear Lower Spoiler)






a. Remove the 4 screws, 2 clips, 3 nuts and rear floor board.

3. REMOVE REAR BUMPER ASSEMBLY (w/Rear Lower Spoiler)






a. Put protective tape around the rear bumper assembly.
b. Using a screwdriver, open the 2 rear bumper plates.






HINT: Tape the screwdriver tip before use.

c. Remove the 6 screws.






d. Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.






HINT: Use the same procedures for the RH side and LH side.

e. Remove the rear bumper assembly.

INSTALLATION

1. INSTALL REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler)






a. Engage each claw.
b. Install the rear bumper assembly with the 6 screws and 2 clips.
c. Install the 2 rear bumper plates.






2. INSTALL REAR BUMPER ASSEMBLY (w/ Rear Lower Spoiler)






a. Engage each claw.
b. Install the rear bumper assembly with the 6 screws.
c. Install the 2 rear bumper plates.






3. INSTALL REAR FLOOR BOARD (w/ Rear Lower Spoiler)






a. Install the rear floor board with the 3 nuts, 2 clips and 4 screws.