Engine Control Module: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
3. REMOVE AIR CLEANER INLET ASSEMBLY
4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
6. REMOVE AIR CLEANER BRACKET
a. Remove the 2 bolts and air cleaner bracket.
7. DISCONNECT ECM CONNECTOR
a. Disconnect the 2 ECM connectors.
1. Raise the levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.
8. REMOVE ECM
a. Remove the 3 bolts of the ECM with bracket.
b. Remove the ECM with bracket.
c. Remove the 4 screws and ECM bracket.
INSTALLATION
1. INSTALL ECM
a. Install the bracket to the ECM with the 4 screws.
Torque: 3.0 N.m (30 kgf.cm, 27 in.lbf)
b. Install the ECM with the 3 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
2. CONNECT CONNECTOR
a. Connect the 2 ECM connectors.
NOTE: When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.
1. Connect the 2 ECM connectors and lower the 2 levers.
NOTE: Make sure that the 2 levers are securely lowered.
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
5. INSTALL ENGINE COVER SUB-ASSEMBLY
6. RESET MEMORY
a. When replacing the ECM, perform the RESET MEMORY procedure (A/T initialization).