Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2007 >> Camry L4-2.4L (2AZ-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag >> Service and Repair >> Removal and Replacement >> Front Passenger Airbag Assembly

Front Passenger Airbag Assembly

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT
2. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (Refer to Restraint Systems Service Precautions).

3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

5. REMOVE LOWER NO. 3 STEERING WHEEL COVER
6. REMOVE LOWER NO. 2 STEERING WHEEL COVER
7. REMOVE STEERING PAD
8. REMOVE STEERING WHEEL ASSEMBLY
9. REMOVE FRONT DOOR SCUFF PLATE LH
10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made)
12. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made)
13. REMOVE STEERING COLUMN COVER (for TMC Made)
14. REMOVE STEERING COLUMN COVER (for TMMK Made)
15. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
16. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
17. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (W/O Smart Key System)
18. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (W/ Smart Key System)
19. REMOVE INSTRUMENT CLUSTER FINISH PANEL
20. REMOVE COMBINATION METER ASSEMBLY (for TMC Made)
21. REMOVE COMBINATION METER ASSEMBLY (for TMMK Made)
22. REMOVE FRONT DOOR SCUFF PLATE RH
23. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
24. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY
25. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made)
26. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made)
27. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY




a. Disconnect the connector.

28. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)
29. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
30. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
31. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
32. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle)
33. REMOVE UPPER CONSOLE PANEL (for Manual Transaxle)
34. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle)
35. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle)
36. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY(for TMC Made)
37. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made)
38. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY
39. REMOVE RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (W/O Navigation System)
40. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (W/ Navigation System)
41. REMOVE CONSOLE BOX POCKET
42. REMOVE CONSOLE BOX CARPET
43. REMOVE CONSOLE BOX ASSEMBLY (for TMC Made)
44. REMOVE CONSOLE BOX ASSEMBLY (for TMMK Made)
45. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made)
46. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made)
47. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made)
48. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made)
49. REMOVE FRONT PILLAR GARNISH LH
50. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY
51. REMOVE INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY
52. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)
53. REMOVE FRONT PILLAR GARNISH RH
54. REMOVE INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY
55. REMOVE INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY
56. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)
57. REMOVE NO. 1 DEFROSTER NOZZLE GARNISH
58. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made)
59. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made)
60. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY




a. Remove the 2 screws.




b. Disengage the 10 hooks and remove the front passenger airbag assembly from the instrument panel.

61. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY




a. Disconnect the 2 connectors.
b. Remove the clamp and the instrument panel wire assembly from the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

INSTALLATION

1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY




a. Connect the 2 connectors.
b. Install the clamp and the instrument panel wire assembly on the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY




a. Engage the 10 hooks and install the front passenger airbag assembly on the instrument panel.




b. Install the 2 screws.

3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made)
4. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made)
5. INSTALL NO. 1 DEFROSTER NOZZLE GARNISH
6. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)
7. INSTALL INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY
8. INSTALL INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY
9. INSTALL FRONT PILLAR GARNISH LH
10. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)
11. INSTALL INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY
12. INSTALL INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY
13. INSTALL FRONT PILLAR GARNISH RH
14. INSTALL NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made)
15. INSTALL NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made)
16. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made)
17. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made)
18. INSTALL CONSOLE BOX ASSEMBLY (for TMC Made)
19. INSTALL CONSOLE BOX ASSEMBLY (for TMMK Made)
20. INSTALL CONSOLE BOX CARPET
21. INSTALL CONSOLE BOX POCKET
22. INSTALL RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (W/O Navigation System)
23. INSTALL NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (W/ Navigation System)
24. INSTALL INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY
25. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made)
26. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made)
27. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle)
28. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle)
29. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle)
30. INSTALL UPPER CONSOLE PANEL (for Manual Transaxle)
31. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
32. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
33. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)
34. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
35. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY




a. Connect the connector.

36. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made)
37. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made)
38. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY
39. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
40. INSTALL FRONT DOOR SCUFF PLATE RH
41. INSTALL COMBINATION METER ASSEMBLY (for TMC Made)
42. INSTALL COMBINATION METER ASSEMBLY (for TMMK Made)
43. INSTALL INSTRUMENT CLUSTER FINISH PANEL
44. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (W/O Smart Key System)
45. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (W/ Smart Key System)
46. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
47. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
48. ADJUST SPIRAL CABLE SUB-ASSEMBLY
49. INSTALL STEERING COLUMN COVER (for TMC Made)
50. INSTALL STEERING COLUMN COVER (for TMMK Made)
51. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made)
52. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made)
53. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
54. INSTALL FRONT DOOR SCUFF PLATE LH
55. INSTALL STEERING WHEEL ASSEMBLY
56. INSTALL STEERING PAD
57. INSTALL LOWER NO. 3 STEERING WHEEL COVER
58. INSTALL LOWER NO. 2 STEERING WHEEL COVER
59. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
60. INSPECT STEERING PAD
61. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.
pro multis · About Operation CHARM